Design & Engineering Consultancy

Load analysis, AutoCAD design and independent technical review before money is committed

Design & Engineering Consultancy

Good projects are decided on paper first. Our design service turns a brief into a single line diagram, load analysis, fault level study and equipment specification that contractors can price and consultants can check.

We also act as the owner’s technical reviewer: checking contractor designs, witnessing tests and sitting in handover meetings so the client is never the least-informed party in the room.

What We Cover

Load analysis, demand estimates and diversity assumptions
Single line diagrams and AutoCAD layout drawings
Cable sizing, discrimination and fault level studies
Tender document review and contractor design checking

What You Receive

Calculation pack with load schedule and fault levels
Drawing set: SLD, layouts and details in DWG and PDF
Written specification suitable for tender
Review comments issued against third-party designs

Information To Get Started

Project description, drawings and architectural layouts

Supply capacity known or assumed

Applicable standards or client engineering guidelines

Stage you need us at: concept, tender or construction

A project needs stamped-quality drawings before pricing

Contractor and consultant designs disagree

Resolve the electrical requirements before equipment is ordered.

Information to send

Concept or single-line diagram
Connected loads and supply information
Room layout and expansion allowance

Scope to agree

Design basis
Distribution arrangement
Equipment schedule and review drawings

What changes the selection?

Equipment duty, installation conditions, available fault current, control interfaces and expansion plans all affect the specification. Agree the required drawings, tests and handover records before placing an order.

Request a scope review ↗

Open the real estate developers & building services hub and calculators ↗

Specify the whole working system.

Start with the equipment duty. Add the control, protection and measurement functions that your project needs; these are options to review, not a pre-approved assembly.